INSTALLATION
Removal / installation · Vehicles built from Jun 2011
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the RH side.
| 1.
INSTALL FRONT SEAT ASSEMBLY |
 |
Place the seat in the cabin.
- NOTICE:
- Be careful not to damage the vehicle body.
w/ Occupant detection sensor:
Connect the connector under the seat.
Install the seat with the 4 bolts.
-
Torque:
- 37 N*m{
377 kgf*cm
, 27 ft.*lbf
}
- HINT:
- Tighten the bolts in the order indicated in the illustration.
Pass the inner belts through the hole of the seat cushion.
| 2.
INSTALL FRONT SEAT HEADREST ASSEMBLY |
|
| 3.
INSTALL SEAT TRACK COVER LH (for Double Cab) |
 |
- Attach the 5 claws to install the cover.
| 4.
INSTALL SEAT TRACK COVER RH (for Double Cab) |
 |
- HINT:
- Use the same procedures described for the LH side.
| 5.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
|
| 6.
PERFORM INITIALIZATION |
 |
Perform initialization (Click here).
- NOTICE:
- Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.