2014 Hilux · Service Manual BODY

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2011

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. REMOVE FRONT SEAT CUSHION SHIELD INNER RH

  1. B112769
    Remove the screw.

  1. Using a screwdriver, detach the 2 claws and remove the cushion shield.

    HINT:
    Tape the screwdriver tip before use.


2. REMOVE RECLINING ADJUSTER RELEASE HANDLE RH

  1. B112297
    Remove the screw and release handle.


3. REMOVE FRONT SEAT CUSHION SHIELD RH

HINT:
Use the same procedures described for the cushion shield inner RH.


4. REMOVE FRONT SEATBACK ASSEMBLY

  1. B112300
    Remove the 4 bolts and seatback.


5. REMOVE SEATBACK COVER WITH PAD

B207669E01
  1. Remove the hog rings.

  1. Open the 2 pieces of fastening tape. Then open the lower part of the seatback cover with pad.

  1. Roll up the bottom portion of the seatback cover with pad until it is possible to reach the headrest supports inside the seatback assembly.

  1. B207679
    Detach the 4 claws and remove the 2 headrest supports.

  1. Remove the seatback cover with pad from the front seatback spring.


6. REMOVE FRONT SEATBACK COVER

  1. B207670
    Remove the hog rings and front seatback cover from the front seatback pad.


7. REMOVE FRONT SEAT CUSHION COVER (for TSAM Made)

NOTICE:
As the front seat cushion pad is affixed to the front seat cushion frame, do not remove the pad from the frame unless it is necessary to replace the pad. If the pad is removed from the frame, make sure to replace the pad.

  1. w/ Occupant detection sensor:
    Detach the wire harness clamp.

  1. If reusing the front seat cushion pad:

    1. B112303E04
      Remove the hog rings.

    2. B112299E02
      Remove the hog rings and front seat cushion cover from the front seat cushion frame with front seat cushion pad.

  1. If replacing the front seat cushion pad:

    1. B112303E04
      Remove the hog rings.

    2. B112299E02
      Remove the hog rings and front seat cushion cover from the front seat cushion frame with front seat cushion pad.

    3. Remove the front seat cushion pad from the front seat cushion frame.


8. REMOVE FRONT SEAT CUSHION COVER (for TMT Made)

NOTICE:
As the front seat cushion pad is affixed to the front seat cushion frame, do not remove the pad from the frame unless it is necessary to replace the pad. If the pad is removed from the frame, make sure to replace the pad.

  1. w/ Occupant detection sensor:
    Detach the wire harness clamp.

  1. If reusing the front seat cushion pad:

    1. B257803E01
      Remove the hog rings and detach the hooks.

    2. B112299E02
      Remove the hog rings and front seat cushion cover from the front seat cushion frame with front seat cushion pad.

  1. If replacing the front seat cushion pad:

    1. B257803E01
      Remove the hog rings and detach the hooks.

    2. B112299E02
      Remove the hog rings and front seat cushion cover from the front seat cushion frame with front seat cushion pad.

    3. Remove the front seat cushion pad from the front seat cushion frame.

← REMOVAL (from Jun 2011)REASSEMBLY (from Jun 2011) →