P0135/21 Oxygen Sensor Heater Circuit (Bank 1 Sensor 1)
Diagnostic trouble codes · Vehicles built from Jun 2011
DESCRIPTION
Refer to DTC P0130/21 (Click here).| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0135/21 |
Open or short in heater circuit of oxygen sensor for 0.5 seconds or more |
|
- HINT:
- Sensor 1 refers to the sensor closer to the engine assembly.
WIRING DIAGRAM
Refer to DTC P0130/21 (Click here).INSPECTION PROCEDURE
- HINT:
- Read freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
| 1. INSPECT HEATED OXYGEN SENSOR |
![]() ![]() |
Disconnect the H6 sensor connector.
Measure the resistance of the sensor.
- Standard resistance:
Tester Connection
Condition
Specified Condition
1 (HT1A) - 2 (+B)
20°C (68°F)
5 to 10 Ω
1 (HT1A) - 4 (E2)
-
10 kΩ or higher
|
|
||||
| OK | |
| 2. CHECK WIRE HARNESS (+B VOLTAGE) |
![]() ![]() |
Disconnect the H6 heated oxygen sensor connector.
Turn the ignition switch ON.
Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester Connection
Specified Condition
H6-2 (+B) - Body ground
9 to 14 V
|
|
||||
| NG | |
| 3. INSPECT INTEGRATION NO.1 RELAY (MAIN RELAY) |
![]() ![]() |
Remove the integration relay from the engine room junction block (Click here).
Measure the voltage of the MAIN relay.
- Standard voltage:
Tester Connection
Condition
Specified Condition
1J-5 - Body ground
Ignition switch ON
10 to 14 V
|
|
||||
| OK | |
| 4. CHECK WIRE HARNESS (HEATED OXYGEN SENSOR - ECM, INTEGRATION RELAY (MAIN RELAY)) |
![]() ![]() |
Disconnect the H6 sensor connector.
Disconnect the E12 ECM connector.
Disconnect the 1J connector from the engine room junction block (Click here).
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
H6-1 - E12-1 (HT1A)
Below 1 Ω
H6-2 (+B) - 1J-5
Below 1 Ω
H6-1 or E12-1 (HT1A) - Body ground
10 kΩ or higher
H6-2 (+B) or 1J-5 - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 5. CHECK IF DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
- Result:
Display (DTC output)
Proceed to
No output
A
Heated oxygen sensor circuit DTCs
B
|
|
||||
| A | ||
| ||





