Home › ENGINE › 2TR-FE ENGINE CONTROL SYSTEM › SFI SYSTEM
MIL Circuit
Circuit diagnosis · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The MIL is used to inform the user when the ECM has detected a vehicle malfunction. By turning the ignition switch ON, power is supplied to the MIL circuit, and the ECM provides the circuit ground that illuminates the MIL. Operation of the MIL should be checked visually: When the ignition switch is first turned ON, the MIL should illuminate. When the engine is started, the MIL should turn off. WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK THAT MIL IS ILLUMINATED
Perform troubleshooting in accordance with the chart below.
Result:
Condition
Proceed to
MIL remains ON
A
MIL does not illuminate
B
B
A
2. CHECK IF MIL TURNS OFF
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the intelligent tester ON.
Check if DTCs have been stored (Click here ). If DTCs are present, write them down.
Clear the DTCs using the intelligent tester (Click here ).
Check that the MIL turns off.
OK:
The MIL turns off.
OK
REPAIR CIRCUIT INDICATED BY OUTPUT DTC
NG
3. CHECK WIRE HARNESS (FOR SHORT)
Disconnect the E10 ECM connector.
Turn the ignition switch ON.
Check that the MIL is not illuminated.
OK:
The MIL is not illuminated.
OK
NG
4. CHECK WIRE HARNESS (ECM - COMBINATION METER)
Disconnect the E10 ECM connector.
Disconnect the C25 combination meter connector.
Measure the resistance of the wire harness side connectors.
Standard resistance:
Tester Connection
Specified Condition
E10-30 (W) - C25-39
Below 1 Ω
E10-30 (W) or C25-39 - Body ground
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK
REPLACE COMBINATION METER ASSEMBLY
5. CHECK IF MIL ILLUMINATES
Check that the MIL illuminates when turning the ignition switch ON.
OK:
The MIL illuminates.
OK
NG
6. CHECK THAT ENGINE STARTS
Turn the ignition switch ON.
Start the engine.
Result
Proceed To
Engine starts
A
Engine does not start*
B
HINT:
*: The intelligent tester cannot communicate with the ECM.
B
A
7. INSPECT COMBINATION METER ASSEMBLY (MIL CIRCUIT)
See the combination meter troubleshooting procedure (Click here ).
NG
REPAIR OR REPLACE BULB OR COMBINATION METER ASSEMBLY
OK
REPAIR OR REPLACE HARNESS AND CONNECTOR (COMBINATION METER - ECM)