2014 Hilux · Service Manual ENGINE

MIL Circuit

Circuit diagnosis · Vehicles built Jun 2011 – Oct 2011

Versions by build date: Jun 2011 – Oct 2011 Nov 2011 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The MIL is used to inform the user when the ECM has detected a vehicle malfunction.
By turning the ignition switch ON, power is supplied to the MIL circuit, and the ECM provides the circuit ground that illuminates the MIL.
Operation of the MIL should be checked visually:
When the ignition switch is first turned ON, the MIL should illuminate. When the engine is started, the MIL should turn off.

WIRING DIAGRAM

A261036E01

INSPECTION PROCEDURE


1. CHECK MIL CONDITION

HINT:
Use the table below to troubleshoot each problem symptom.

Result:
Condition
Proceed to
MIL remains ON
A
MIL does not illuminate
B



B
Go to step 5
A


2. CHECK IF MIL TURNS OFF
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON and turn the intelligent tester ON.

  1. Check if DTCs have been stored (Click here). If DTCs are present, write them down.

  1. Clear the DTCs using the intelligent tester (Click here).

  1. Check that the MIL turns off.

    OK:
    The MIL turns off.



OK
REPAIR CIRCUIT INDICATED BY OUTPUT DTC
NG


3. CHECK WIRE HARNESS (FOR SHORT)
A062417E04
  1. Disconnect the E20 ECM connector.

  1. Turn the ignition switch ON.

  1. Check that the MIL is not illuminated.

    OK:
    The MIL is not illuminated.



OK
REPLACE ECM
NG


4. CHECK WIRE HARNESS (ECM - COMBINATION METER)
A121710E01
  1. Disconnect the E20 ECM connector.

  1. Disconnect the C8 combination meter connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E20-5 (W) - C8-39
    Below 1 Ω
    E20-5 (W) or C8-39 - Body ground
    10 kΩ or higher



OK
REPAIR OR REPLACE HARNESS OR CONNECTOR
NG

REPLACE COMBINATION METER

5. CHECK IF MIL ILLUMINATES
  1. Check that the MIL illuminates when turning the ignition switch ON.

    OK:
    The MIL illuminates.



OK
NORMAL
NG


6. INSPECT COMBINATION METER (MIL CIRCUIT)
  1. See the combination meter troubleshooting procedures (Click here).



NG
REPAIR OR REPLACE COMBINATION METER
OK

REPAIR OR REPLACE HARNESS AND CONNECTOR (COMBINATION METER - ECM)


← Brake Override System (from Aug 2014)MIL Circuit (Nov 2011 – Jul 2013) →