2014 Hilux · Service Manual DRIVE LINE

INSTALLATION

Removal / installation · Vehicles built from Jun 2011


1. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (for 2WD and Pre-Runner)

C098710E01
  1. Remove SST from the extension housing.

  1. Install the propeller shaft into the extension housing.

  1. Install the center support bearing bracket with the 2 plates and 2 bolts. Tighten the bolts as much as possible by hand.

  1. C119752E01
    Align the matchmarks on the propeller shaft flange and differential flange.

  1. Install the propeller shaft with the 4 bolts, 4 washers and 4 nuts.

    Torque:
    88 N*m{ 897 kgf*cm , 65 ft.*lbf }

  1. C118622E01
    Unload the vehicle. The center line of the center bearing and center bearing housing (see illustration) must be adjusted to within 0 +-1 mm (0 +-0.04 in.) of each other. Measure the difference along the vehicle front/rear axis.

  1. Tighten the 2 bolts of the center support bearing bracket.

    Torque:
    36 N*m{ 367 kgf*cm , 27 ft.*lbf }


2. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 4WD)

C118613E01
  1. Align the matchmarks on the propeller shaft flange and transfer flange.

  1. Install the propeller shaft with the 4 nuts and 4 washers.

    Torque:
    88 N*m{ 897 kgf*cm , 65 ft.*lbf }

  1. C118612
    Install the center support bearing bracket with the 2 plates and 2 bolts. Tighten the bolts as much as possible by hand.

  1. Align the matchmarks on the propeller shaft flange and differential flange.

  1. C119752E01
    Install the propeller shaft with the 4 bolts, 4 washers and 4 nuts.

    Torque:
    88 N*m{ 897 kgf*cm , 65 ft.*lbf }

  1. C118622E01
    Unload the vehicle. The center line of the center bearing and center bearing housing (see illustration) must be adjusted to within 0 +-1 mm (0 +-0.04 in.) of each other. Measure the difference along the vehicle front/rear axis.

  1. Tighten the 2 bolts of the center support bearing bracket.

    Torque:
    36 N*m{ 367 kgf*cm , 27 ft.*lbf }

← REASSEMBLY (from Jun 2011)COMPONENTS (from Jun 2011) →