2014 Hilux · Service Manual DRIVE LINE

INSTALLATION

Removal / installation · Vehicles built from Jun 2011


1. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (for 2WD)

C098710E01
  1. Remove SST from the extension housing.

  1. Install the propeller shaft into the extension housing.

  1. A098693E01
    Install the center support bearing bracket with the 2 plates and 2 bolts. Tighten the bolts as much as possible by hand.

  1. F050137E01
    Align the matchmarks on the propeller shaft flange and differential flange.

  1. Install the propeller shaft with the 4 bolts, 4 washers and 4 nuts.

    Torque:
    88 N*m{ 897 kgf*cm , 65 ft.*lbf }

  1. A098689E01
    Unload the vehicle. The center line of the center bearing and center bearing housing (see illustration) must be adjusted to within 0 +-1 mm (0 +-0.04 in.) of each other. Measure the difference along the vehicle front/rear axis.

  1. Tighten the 2 bolts of the center support bearing bracket.

    Torque:
    36 N*m{ 367 kgf*cm , 27 ft.*lbf }


2. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (for 4WD)

C098700E01
  1. Align the matchmarks on the propeller shaft flange and differential flange.

  1. Install the propeller shaft with the 4 bolts, 4 nuts and 4 washers.

    Torque:
    88 N*m{ 897 kgf*cm , 65 ft.*lbf }

  1. A098693E01
    Install the center support bearing bracket with the 2 bolts. Tighten the bolts as much as possible by hand.

  1. Align the matchmarks on the propeller shaft flange and transfer flange.

  1. C098699E01
    Install the propeller shaft with the 4 bolts, 4 washers and 4 nuts.

    Torque:
    88 N*m{ 897 kgf*cm , 65 ft.*lbf }

  1. A098689E01
    Unload the vehicle. The center line of the center bearing and center bearing housing (see illustration) must be adjusted to within 0 +-1 mm (0 +-0.04 in.) of each other. Measure the difference along the vehicle front/rear axis.

  1. Tighten the 2 bolts of the center support bearing bracket.

    Torque:
    36 N*m{ 367 kgf*cm , 26 ft.*lbf }

← REASSEMBLY (from Jun 2011)COMPONENTS (from Jun 2011) →