2014 Hilux · Service Manual SUSPENSION & AXLE

REPLACEMENT

Removal / installation · Vehicles built from Jun 2011

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. REMOVE FRONT WHEEL

2. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH (for 2WD)

C111187
  1. Remove the 2 bolts and disc brake cylinder.

  1. Support the brake cylinder securely.


3. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH (for 4WD and Pre-Runner)

F042731E01
  1. Remove the bolt and brake tube bracket from the steering knuckle.

  1. C111186
    Remove the 2 bolts and disc brake cylinder.

  1. Support the brake cylinder securely.


4. REMOVE FRONT DISC

5. REMOVE FRONT AXLE HUB BOLT

F044194E01
  1. Temporarily install 2 nuts to the hub bolts as shown in the illustration.

  1. Using SST and a screwdriver, remove the hub bolt.

    SST
    09650-17011  


6. INSTALL FRONT AXLE HUB BOLT

C098706E01
  1. Temporarily install a plate washer and nut to a new hub bolt as shown in the illustration.

  1. Using a screwdriver to hold the front axle, install a new hub bolt by tightening the nut. Then remove the nut and plate washer.

  1. Remove the 2 nuts from the hub bolts.


7. INSTALL FRONT DISC

8. INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY LH (for 4WD and Pre-Runner)

C111186
  1. Install the disc brake cylinder with the 2 bolts.

    Torque:
    123 N*m{ 1,254 kgf*cm , 91 ft.*lbf }

  1. F042731E01
    Install the brake tube bracket to the steering knuckle with the bolt.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }


9. INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY LH (for 2WD)

C111187
  1. Install the disc brake cylinder with the 2 bolts.

    Torque:
    126 N*m{ 1,285 kgf*cm , 93 ft.*lbf }


10. INSTALL FRONT WHEEL

Torque:
152 N*m{ 1,550 kgf*cm , 112 ft.*lbf } for 2WD (steel type)
121 N*m{ 1,234 kgf*cm , 89 ft.*lbf } for 2WD (aluminum type)
105 N*m{ 1,071 kgf*cm , 77 ft.*lbf } for 4WD and Pre-Runner

← COMPONENTS (from Jun 2011)COMPONENTS (from Jun 2011) →