2014 Hilux · Service Manual BRAKE

PRECAUTION

Precautions · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

CAUTION:
  1. When there are problems with contact points of the terminals and improper part installation, the installation / removal of the suspected part may return the system to normal or may only temporarily return the system to normal.
  2. To determine the malfunctioning area, use DTCs, freeze frame data and other data to help determine conditions at the time of the malfunction. Write down the data before disconnecting connectors or installing / removing parts.
  3. The Anti-lock Brake System (ABS) may be affected by malfunctions in other systems. Check for DTCs in other systems and, if present, troubleshoot those DTCs first.
  4. Unless specified, the ignition switch must be OFF when installing / removing the brake actuator and the ABS's connectors.
  5. After the brake actuator or an ABS connector has been removed and reinstalled, be sure to check for DTCs. Also, perform the test mode inspection to make sure the part is functioning normally.

NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following system after the cable is reconnected.

System Name
See procedure
Meter / Gauge System
Click here
← INSPECTION (from Aug 2013)PRECAUTION (Aug 2012 – Jul 2013) →