DATA LIST / ACTIVE TEST
System information · Vehicles built from Jun 2011
| READ DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
According to the display on the tester, read the Data List.
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
ABS Motor Relay
ABS motor relay/ ON or OFF
ON: Motor relay on
OFF: Motor relay off
-
Solenoid Relay
Solenoid relay/ ON or OFF
ON: Solenoid relay on
OFF: Solenoid relay off
-
Stop Light SW
Stop light switch/ ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
-
Parking Brake SW
Parking brake switch/ ON or OFF
ON: Parking brake applied
OFF: Parking brake released
ON is also displayed when either condition is met: - The brake fluid level is low (the brake fluid level warning switch is on).
- The vacuum in the brake booster decreases (the vacuum warning switch is on).*
FR Wheel ABS Control
Front wheel RH ABS operation/ Before or Operate
Before: No ABS operation
Operate: During ABS operation
-
FL Wheel ABS Control
Front wheel LH ABS operation/ Before or Operate
Before: No ABS operation
Operate: During ABS operation
-
RR Wheel ABS Control
Rear wheel RH ABS operation/ Before or Operate
Before: No ABS operation
Operate: During ABS operation
-
RL Wheel ABS Control
Rear wheel LH ABS operation/ Before or Operate
Before: No ABS operation
Operate: During ABS operation
-
FR Wheel Speed
Front speed sensor RH reading/
Min.: 0 km/h (0 mph)
Max.: 326 km/h (202 mph)
Actual wheel speed
No large fluctuations when driving at a constant speed.
FL Wheel Speed
Front speed sensor LH reading/
Min.: 0 km/h (0 mph)
Max.: 326 km/h (202 mph)
Actual wheel speed
No large fluctuations when driving at a constant speed.
RR Wheel Speed
Rear speed sensor RH reading/
Min.: 0 km/h (0 mph)
Max.: 326 km/h (202 mph)
Actual wheel speed
No large fluctuations when driving at a constant speed.
RL Wheel Speed
Rear speed sensor LH reading/
Min.: 0 km/h (0 mph)
Max.: 326 km/h (202 mph)
Actual wheel speed
No large fluctuations when driving at a constant speed.
Deceleration Sensor1
Deceleration sensor 1 reading/
Min.: -1.86 G
Max.: 1.85 G
Changes continuously during acceleration/deceleration
-
Deceleration Sensor2
Deceleration sensor 2 reading/
Min.: -1.86 G
Max.: 1.85 G
Changes continuously during acceleration/deceleration
-
ECU IG Power Voltage
ECU power supply voltage/ too Low, Normal or too High
Normal
-
Solenoid (SFRR)
Front wheel RH release solenoid/ ON or OFF
ON: Operates
OFF: Does not operate
-
Solenoid (SFRH)
Front wheel RH hold solenoid/ ON or OFF
ON: Operates
OFF: Does not operate
-
Solenoid (SFLR)
Front wheel LH release solenoid/ ON or OFF
ON: Operates
OFF: Does not operate
-
Solenoid (SFLH)
Front wheel LH hold solenoid/ ON or OFF
ON: Operates
OFF: Does not operate
-
Solenoid (SRRR)
Rear wheel release solenoid/ ON or OFF
ON: Operates
OFF: Does not operate
-
Solenoid (SRRH)
Rear wheel hold solenoid/ ON or OFF
ON: Operates
OFF: Does not operate
-
FR Speed Open
Front speed sensor RH open circuit detection/ Opn_Det or Normal
Normal
-
FL Speed Open
Front speed sensor LH open circuit detection/ Opn_Det or Normal
Normal
-
RR Speed Open
Rear speed sensor RH open circuit detection/ Opn_Det or Normal
Normal
-
RL Speed Open
Rear speed sensor LH open circuit detection/ Opn_Det or Normal
Normal
-
Test Mode
Test mode/ Normal or Test
Normal: Normal mode
Test: Test mode
-
Number of DTC
Number of DTCs stored/
Min.: 0
Max.: 255
0
-
- *: for 1KD-FTV, 2KD-FTV and 5L-E
- The brake fluid level is low (the brake fluid level warning switch is on).
| PERFORM ACTIVE TEST |
- HINT:
- Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.
According to the display on the tester, perform the Active Test.
ABS/VSC/TRC Tester Display
Test Part
Control Range
Diagnostic Note
ABS Solenoid (SFRR)
Front wheel RH release solenoid
ON / OFF
The operating sound of the solenoid (clicking sound) can be heard.
ABS Solenoid (SFRH)
Front wheel RH hold solenoid
ON / OFF
The operating sound of the solenoid (clicking sound) can be heard.
ABS Solenoid (SFLR)
Front wheel LH release solenoid
ON / OFF
The operating sound of the solenoid (clicking sound) can be heard.
ABS Solenoid (SFLH)
Front wheel LH hold solenoid
ON / OFF
The operating sound of the solenoid (clicking sound) can be heard.
ABS Solenoid (SRRR)
Rear wheel release solenoid
ON / OFF
The operating sound of the solenoid (clicking sound) can be heard.
ABS Solenoid (SRRH)
Rear wheel hold solenoid
ON / OFF
The operating sound of the solenoid (clicking sound) can be heard.
ABS Solenoid (SFRR & SFRH)
Front wheel RH release and hold solenoid
ON / OFF
The operating sound of the solenoid (clicking sound) can be heard.
ABS Solenoid (SFLR & SFLH)
Front wheel LH release and hold solenoid
ON / OFF
The operating sound of the solenoid (clicking sound) can be heard.
ABS Solenoid (SRRR & SRRH)
Rear wheel release and hold solenoid
ON / OFF
The operating sound of the solenoid (clicking sound) can be heard.
ABS Solenoid (SFRH & SFLH)
Front wheel RH and LH hold solenoid
ON / OFF
The operating sound of the solenoid (clicking sound) can be heard.
Solenoid Relay
ABS solenoid relay
ON / OFF
Check for DTCs after performing this Active Test. If no codes are output, the solenoid relay is operating normally.
ABS Motor Relay
ABS motor relay
ON / OFF
The operating sound of the motor can be heard.
ABS Warning Light
ABS warning light
ON / OFF
Observe the combination meter.