2014 Hilux · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2013 from Aug 2013

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. PREPARATION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


3. REMOVE LOWER NO. 3 STEERING WHEEL COVER

  1. B277147E01
    Using a screwdriver wrapped with protective tape, detach the 2 claws and remove the lower No. 3 steering wheel cover.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Protective tape the screwdriver tip before use.


4. REMOVE LOWER NO. 2 STEERING WHEEL COVER

  1. B277148E01
    Using a screwdriver wrapped with protective tape, detach the 2 claws and remove the lower No. 2 steering wheel cover.
    Text in Illustration 
    *A
    w/o Cruise Control System
    *B
    w/ Cruise Control System
    *1
    Protective Tape

    HINT:
    Protective tape the screwdriver tip before use.


5. REMOVE STEERING PAD ASSEMBLY

  1. B281336E01
    Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.
    Text in Illustration 
    *1
    Screw Case

  1. B277210
    Pull out the steering pad from the steering wheel as shown in the illustration. Then support the steering pad with one hand.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Disconnect the horn connector.

  1. Disconnect the connector and remove the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

← REMOVAL (Jun 2011 – Jul 2013)INSTALLATION (Jun 2011 – Jul 2012) →