REMOVAL
Removal / installation · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
- CAUTION:
- Be sure to read the precautionary notices concerning the SRS airbag system before servicing (Click here).
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
|
 |
Slightly bend the upper part of the glove compartment door to release the 2 stoppers and open the glove compartment door until it is horizontal.
Text in Illustration
*1
|
Stopper
|
- Pull the glove compartment door toward the rear of the vehicle to detach the 2 hinges and remove the glove compartment door.
Text in Illustration
*1
|
Hinge
|
| 3.
REMOVE FRONT PASSENGER AIRBAG ASSEMBLY |
 |
Disconnect the connector from the airbag.
- NOTICE:
- When handling the airbag connector, do not damage the airbag wire harness.
- Remove the 2 bolts.
Detach the clamp from the bracket.
- Detach the 12 claws and remove the airbag.