INSTALLATION
Removal / installation · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
- HINT:
- The procedures listed below are for the LH side.
- Other than areas where instructions are provided, use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
| 1. INSTALL FRONT SPEED SENSOR LH |
Install the 2 harness clamps with the 2 bolts.

- Torque:
- 32 N*m{ 326 kgf*cm , 24 ft.*lbf }
- NOTICE:
- When installing the clamp, do not twist the wire harness.
- Make sure the clamp rotation stopper touches the installation position.
- When installing the clamp, do not twist the wire harness.
Install the speed sensor with the bolt.
- Torque:
- 8.5 N*m{ 87 kgf*cm , 75 in.*lbf }
- NOTICE:
- Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
- While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.
- After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.
- When installing the sensor, do not twist the wire harness.
- Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
Install the harness clamp with the bolt.

- Torque:
- 32 N*m{ 326 kgf*cm , 24 ft.*lbf }
- NOTICE:
- When installing the clamp, do not twist the wire harness.
- Make sure the clamp rotation stopper touches the installation position.
- When installing the clamp, do not twist the wire harness.
Install the harness clamp with the bolt.

- Torque:
- 32 N*m{ 326 kgf*cm , 24 ft.*lbf }
- NOTICE:
- When installing the clamp, do not twist the wire harness.
- Make sure the clamp rotation stopper touches the installation position.
- When installing the clamp, do not twist the wire harness.
Attach the clamp.
Connect the connector.


- NOTICE:
- Do not attach the connector to the radiator fan shroud before connecting the connector.
- Securely connect the connector.
- Do not attach the connector to the radiator fan shroud before connecting the connector.
Attach the 2 clamps and the connector.
- NOTICE:
- When attaching the clamps, do not twist the wire harness.
| 2. INSTALL FRONT WHEEL |
Install the front wheel.
- Torque:
- for steel wheel:
- 152 N*m{ 1550 kgf*cm , 112 ft.*lbf }
- for aluminum wheel:
- 121 N*m{ 1234 kgf*cm , 89 ft.*lbf }
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 4. CHECK SPEED SENSOR SIGNAL |
Check the speed sensor signal (Click here).
