INSTALLATION
Removal / installation · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
- HINT:
- The procedures listed below are for the LH side.
- Other than areas where instructions are provided, use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
| 1. INSTALL SKID CONTROL SENSOR CLAMP LH |
Install the skid control sensor clamp with the bolt.


- Torque:
- 14 N*m{ 138 kgf*cm , 10 ft.*lbf }
- NOTICE:
- Install the clamp so that the rotation stopper touches the knuckle.
| 2. INSTALL SKID CONTROL SENSOR CLAMP RH |
Install the skid control sensor clamp with the bolt.


- Torque:
- 14 N*m{ 138 kgf*cm , 10 ft.*lbf }
- NOTICE:
- Install the clamp so that the rotation stopper touches the knuckle.
| 3. INSTALL FRONT SPEED SENSOR LH |
Install the speed sensor with the bolt.


- Torque:
- 8.5 N*m{ 87 kgf*cm , 75 ft.*lbf }
- NOTICE:
- Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
- While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.
- After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.
- When installing the sensor, do not twist the wire harness.
- Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
Install the harness clamp with the bolt.
- Torque:
- 32 N*m{ 326 kgf*cm , 24 ft.*lbf }
- NOTICE:
- When installing the clamp, do not twist the wire harness.
- Make sure the clamp rotation stopper touches the installation position.
- When installing the clamp, do not twist the wire harness.
Attach the 2 clamps.
Attach the clamp.

Install the 2 harness clamps with the 2 bolts.
- Torque:
- 32 N*m{ 326 kgf*cm , 24 ft.*lbf }
- NOTICE:
- When installing the clamps, do not twist the wire harness.
- Make sure the clamp rotation stopper touches the installation position.
- When installing the clamps, do not twist the wire harness.
Attach the 2 clamps.

- NOTICE:
- When attaching the clamps, do not twist the wire harness.
Connect the connector.


- NOTICE:
- Do not attach the connector to the radiator fan shroud before connecting the connector.
- Securely connect the connector.
- Do not attach the connector to the radiator fan shroud before connecting the connector.
Attach the 2 clamps and the connector.
- NOTICE:
- When attaching the clamps, do not twist the wire harness.
| 4. INSTALL FRONT WHEEL |
- Torque:
- 105 N*m{ 1071 kgf*cm , 77 ft.*lbf }
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 6. CHECK SPEED SENSOR SIGNAL |
w/ ABS:
Check the speed sensor signal (Click here).
w/ VSC:
Check the speed sensor signal (Click here).
