2014 Hilux · Service Manual BRAKE

BLEEDING

Removal / installation · Vehicles built Jun 2011 – Jul 2013

Versions by build date: Jun 2011 – Jul 2013 from Aug 2013

HINT:
If any work is performed on the brake system or if air in the brake lines is suspected, bleed air from the brake system.

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.


1. FILL RESERVOIR WITH BRAKE FLUID

Fluid:
SAE J1703 or FMVSS No. 116 DOT 3


2. BLEED AIR FROM BRAKE MASTER CYLINDER

HINT:
If the master cylinder has been disassembled or if the reservoir becomes empty, bleed air from the master cylinder.

  1. Using a union nut wrench, disconnect the 2 brake lines from the master cylinder.

  1. Slowly depress and hold the brake pedal.

    C238133E02

  1. Cover the outer holes with your finger, and release the pedal.

    C239738E02

  1. Repeat the 2 previous steps 3 or 4 times.

  1. Using a union nut wrench, connect the 2 brake lines to the master cylinder.

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).


3. BLEED AIR FROM LOAD SENSING VALVE BODY
  1. Remove the bleeder plug cap.

  1. Connect the vinyl tube to the bleeder plug.

  1. C184293
    Depress the pedal several times, and then loosen the bleeder plug with the pedal depressed.

  1. When fluid stops coming out, immediately tighten the bleeder plug. Then release the pedal.

  1. Repeat the 2 previous steps until all the air in the brake fluid is gone.

  1. Tighten the bleeder plug.

    Torque:
    11 N*m{ 107 kgf*cm , 8 ft.*lbf }

  1. Install the bleeder plug cap.


4. BLEED AIR FROM BRAKE LINE
  1. Remove the bleeder plug cap.

  1. Connect the vinyl tube to the bleeder plugs.

  1. Depress the pedal several times, and then loosen the bleeder plug with the pedal depressed.

  1. When fluid stops coming out, immediately tighten the bleeder plug. Then release the pedal.

  1. Repeat the 2 previous steps until all the air in the brake fluid is gone.

  1. Tighten the bleeder plug.

    Torque:
    for front brake:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }
    for rear brake (2WD):
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }
    for rear brake (4WD and Pre-Runner):
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Install the cap.

  1. Bleed air from the brake line for each wheel by repeating the above procedures.


5. CHECK BRAKE FLUID LEVEL IN RESERVOIR

  1. F052092
    Check the fluid level.
    If the brake fluid level is lower that the MIN line, check for leaks and inspect the disc brake pads. If necessary, refill the reservoir with brake fluid to the MAX line after repair or replacement.

    Fluid:
    SAE J1703 or FMVSS No. 116 DOT 3

← ON-VEHICLE INSPECTION (from Jun 2011)BLEEDING (from Aug 2013) →