REMOVAL
Removal / installation · Vehicles built from Jun 2011
- NOTICE:
- Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.
| 1. DRAIN BRAKE FLUID |
- NOTICE:
- Wash off brake fluid immediately if it comes in contact with any painted surface.
| 2. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/ ABS) |
for Manual Transmission:
Disconnect the clutch reservoir tube labeled A from the master cylinder.

Disconnect the brake fluid level warning switch connector labeled B.
Using a union nut wrench, disconnect the 5 brake lines labeled C from the master cylinder and 3-way.
Remove the 2 nuts and bracket (with 3-way).


Pull out the master cylinder from the brake booster.
Remove the O-ring from the master cylinder.
| 3. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/o ABS) |
for Manual Transmission:
Disconnect the clutch reservoir tube labeled A from the master cylinder.

Disconnect the brake fluid level warning switch connector labeled B.
Using a union nut wrench, disconnect the 6 brake lines from the master cylinder and 4-way.
Remove the 2 nuts and bracket (with 4-way).


Pull out the master cylinder from the brake booster.
Remove the O-ring from the master cylinder.
