2014 Hilux · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built Jun 2011 – Jul 2013

Versions by build date: Jun 2011 – Jul 2013 from Aug 2013

NOTICE:
Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.


1. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.


2. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/ ABS)

C242466E01
  1. for Manual Transmission:
    Disconnect the clutch reservoir tube labeled A from the master cylinder.

  1. Disconnect the brake fluid level warning switch connector labeled B.

  1. Using a union nut wrench, disconnect the 5 brake lines labeled C from the master cylinder and 3-way.

  1. Remove the 2 nuts and bracket (with 3-way).

    C242467E01

  1. Pull out the master cylinder from the brake booster.

  1. Remove the O-ring from the master cylinder.


3. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/o ABS)

  1. for Manual Transmission:
    Disconnect the clutch reservoir tube labeled A from the master cylinder.

    C242464E01

  1. Disconnect the brake fluid warning switch connector labeled B.

  1. Using a union nut wrench, disconnect the 6 brake lines labeled C from the master cylinder and 4-way.

  1. Remove the 2 nuts and bracket (with 4-way).

    C242465E01

  1. Pull out the master cylinder from the brake booster.

  1. Remove the O-ring from the master cylinder.


4. REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
  1. Remove the screw.

  1. Remove the reservoir and 2 grommets from the master cylinder.

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2013) →