REASSEMBLY
Removal / installation · Vehicles built from Jun 2011
| 1. INSTALL LOAD SENSING SPRING |
![]() ![]() |
Install the valve boot and spring boot to the spring.
Install the 2 rubber plates, 2 collars and 4 bushes to the spring.
- NOTICE:
- Apply lithium soap base glycol grease to all contact surfaces.
- Make sure the valve side and shackle side of the spring are installed properly.
- Apply lithium soap base glycol grease to all contact surfaces.
| 2. INSTALL NO. 1 AND NO. 2 SHACKLES |
Install the adjusting nut and No. 2 shackle to the No. 1 shackle.
Tighten the lock nut.
- Torque:
- 13 N*m{ 127 kgf*cm , 9 ft.*lbf }
Install the No. 1 shackle (with the No. 2 shackle) to the spring.
Install the 2 plate washers, bolt and nut.
| 3. INSTALL LOAD SENSING SPRING ASSEMBLY |
![]() ![]() |
Using pliers, install the spring to the valve body with the clip.
| 4. INSTALL LOAD SENSING VALVE BRACKET |
![]() ![]() |
Install the bracket to the valve.
| 5. INSTALL REAR FLEXIBLE HOSE BRACKET |
![]() ![]() |
Install the bracket and valve set plate to the valve with the 2 nuts.
- Torque:
- 13 N*m{ 127 kgf*cm , 9 ft.*lbf }





