INSTALLATION
Removal / installation · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
- NOTICE:
- When working with FIPG material, perform the following:
- Using a razor blade and gasket scraper, remove all old FIPG material from the gasket surfaces.
- Clean all components thoroughly to remove all foreign matter.
- Clean both sealing surfaces with a non-residue solvent.
- Apply FIPG material in a continuous line approximately 1 mm (0.04 in.) in diameter on the sealing surface.
- Reassemble parts within 10 minutes of applying FIPG material. Failing to do so will require the FIPG material to be removed and reapplied.
- Using a razor blade and gasket scraper, remove all old FIPG material from the gasket surfaces.
| 1. INSTALL TRANSMISSION WIRE |
![]() ![]() |
Coat a new O-ring with ATF, and install it to the transmission wire.
Install the transmission wire to the case, and install the stopper plate with the bolt.
- Torque:
- 5.4 N*m{ 55 kgf*cm , 48 in.*lbf }
Connect the 4 connectors to the 4 shift solenoid valves.

| 2. INSTALL VALVE BODY OIL STRAINER ASSEMBLY |
![]() ![]() |
Install 5 new gaskets.
Install the oil strainer with the 4 bolts.

- Torque:
- 10 N*m{ 102 kgf*cm , 7 ft.*lbf }
- HINT:
- Bolt length:
- 14 mm (0.55 in.) for A
- 20 mm (0.79 in.) for B
- 23 mm (0.91 in.) for C
| 3. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY |
![]() ![]() |
- HINT:
- Remove any packing material and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.
Install the 3 magnets to the locations indicated in the illustration.
Apply FIPG to the oil pan as shown in the illustration.
- FIPG:
- Toyota Genuine Seal Packing 1281, Three Bond 1281 or equivalent
Install the oil pan with the 19 bolts.
- Torque:
- 7.4 N*m{ 75 kgf*cm , 65 in.*lbf }
| 4. INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY |
![]() ![]() |
Coat a new O-ring with ATF, and install it to the oil filler tube.
Install the oil filler tube with the 2 bolts.
- Torque:
- 12 N*m{ 122 kgf*cm , 9 ft.*lbf }
Install the oil dipstick.
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 6. PERFORM INITIALIZATION |
Perform initialization (Click here).
| 7. ADD AUTOMATIC TRANSMISSION FLUID |
Add automatic transmission fluid (Click here).
| 8. INSPECT AUTOMATIC TRANSMISSION FLUID |
Inspect the automatic transmission fluid (Click here).




