INSTALLATION
Removal / installation · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
| 1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
- HINT:
- Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.
Install the park/neutral position switch to the manual valve shaft.
Temporarily install the bolt.

Install a new lock washer and the nut.
- Torque:
- 7.0 N*m{ 71 kgf*cm , 62 in.*lbf }
Push the control shaft rearward as much as possible.

Return the control shaft lever 2 notches to the N position.
Align the neutral basic line with the switch groove, and tighten the bolt.

- Torque:
- 13 N*m{ 130 kgf*cm , 9 ft.*lbf }
Using a screwdriver, bend the tabs of the lock washer.
| 2. CONNECT PARK / NEUTRAL POSITION SWITCH CONNECTOR |
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 4. PERFORM INITIALIZATION |
Perform initialization (Click here ).
- NOTICE:
- Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
| 5. INSPECT SHIFT LEVER POSITION |
Inspect the shift lever position (Click here).
| 6. ADJUST SHIFT LEVER POSITION |
Adjust the shift lever position (Click here ).
| 7. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Apply the parking brake and turn the ignition switch ON.
Depress the brake pedal and check that the engine starts when the shift lever is on N or P, but does not start in other positions.
Check that the back-up lamp illuminates and the reverse warning buzzer sounds when the shift lever is on R, but do not function in other positions.
