2014 Hilux · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Jun 2011


1. INSTALL FLOOR SHIFT ASSEMBLY

  1. G037855E03
    Install the floor shift assembly with the 4 bolts.

    NOTICE:
    Tighten the bolts in the order shown in the illustration.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }

  1. Move the shift lever to L.

  1. Connect the transmission control cable.

  1. Connect the clamp and 2 connectors.


2. ADJUST SHIFT LEVER POSITION
  1. Move the shift lever to N.

  1. G034515E02
    Remove the nut and disconnect the control cable.

  1. C236140E01
    Turn the control shaft lever clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.

  1. While holding the control shaft lever slightly toward the R position side, connect the cable with the nut.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }


3. INSPECT SHIFT LEVER POSITION
  1. When moving the shift lever from P to R with the ignition switch to ON and the brake pedal depressed, make sure that the shift lever moves smoothly and correctly into position.

  1. Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D, and moves in reverse after shifting to R.
    If the results are not as specified, inspect the park/ neutral position switch and check the shift lever.


4. INSTALL CONSOLE BOX ASSEMBLY

B278048E01
  1. Install the console box with the 4 screws and 2 bolts.

  1. Install the 2 clips.

    Text in Illustration 
    *1
    Screw
    *2
    Bolt
    *3
    Clip


5. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

  1. Attach the 12 claws to install the upper console panel.

    B277548E01

    Text in Illustration 
    *A
    for 2WD
    *B
    for 4WD


6. INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY
  1. Attach the 4 claws to install the parking brake hole cover.

← REASSEMBLY (from Jun 2011)COMPONENTS (from Jun 2011) →