DISPOSAL
Removal / installation · Vehicles built from Jun 2011
| 1. DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY LH |
- HINT:
- Use the same procedure for the other front shock absorber.
Fully extend the shock absorber piston rod and fix the shock absorber in place at an angle in a vise or similar tool.

Text in Illustration *a
Approximately 35 mm
Using a drill or similar tool, slowly make a hole approximately 35 mm (1.38 in.) from the top end of the shock absorber and discharge the gas inside of it.
- NOTICE:
- The gas is colorless, odorless and harmless.
- Since the discharged gas may cause chips to fly off, cover the drill with a cloth when making a hole.
- The gas is colorless, odorless and harmless.
