REMOVAL
Removal / installation · Vehicles built from Jun 2011
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
- Use the same procedure for the RH and LH sides.
| 1. REMOVE FRONT WHEEL |
| 2. DISCONNECT FRONT STABILIZER LINK ASSEMBLY LH |
![]() ![]() |
Remove the nut and disconnect the stabilizer link from the lower arm.
- HINT:
- If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.
| 3. DISCONNECT FRONT STABILIZER LINK ASSEMBLY RH |
- HINT:
- Use the same procedure described for the LH side.
| 4. REMOVE FRONT STABILIZER BRACKET |
![]() ![]() |
Remove the 4 bolts and 2 brackets.
| 5. REMOVE FRONT STABILIZER BAR |
Remove the stabilizer bar front from the vehicle body.
| 6. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING |
![]() ![]() |
Remove the nut and bolt.
- HINT:
- While fixing the nut in place, loosen and remove the bolt.
Remove the 3 nuts and shock absorber with coil spring.

| 7. REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT |
Secure SST in a vise.

- SST
- 09727-30021
(09727-00010, 09727-00021, 09727-00031)
Attach the arm of SST to the diameter of the coil spring.

Text in Illustration *a
Correct
*b
Incorrect
- CAUTION:
- Make sure that the coil spring is installed so that the distance between the upper and lower hooks of SST is at the maximum.
- Make sure that the claws of the hooks are securely attached.
- Make sure that the coil spring is installed so that the distance between the upper and lower hooks of SST is at the maximum.
Using SST, compress the coil spring.
- CAUTION:
- If the coil spring bends during the compression, immediately stop the compression and reinstall SST.
- Do not compress the spring until the coil springs contact each other.
- Do not use an impact wrench.
- If the coil spring bends during the compression, immediately stop the compression and reinstall SST.
Hold the shock absorber rod and remove the nut.

- CAUTION:
- Do not remove the nut when the coil spring is not free.
| 8. REMOVE FRONT SHOCK ABSORBER CUSHION RETAINER |
Remove the cushion retainer from the shock absorber.
| 9. REMOVE FRONT SHOCK ABSORBER CUSHION |
Remove the cushion from the shock absorber.
| 10. REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY LH |
Remove the suspension support from the shock absorber.
Remove the cushion retainer from the shock absorber.
| 11. REMOVE FRONT COIL SPRING UPPER INSULATOR LH |
Remove the upper insulator from the coil spring.
| 12. REMOVE FRONT COIL SPRING LH |
Remove the coil spring from the shock absorber.



