2014 Hilux · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Jun 2011

HINT:
  1. Use the same procedure for the RH and LH sides
  2. The procedure listed below is for the LH side.


1. REMOVE FRONT WHEEL

2. REMOVE FRONT SPEED SENSOR LH (w/ ABS)

  1. F049997E01
    Remove the 2 bolts and disconnect the speed sensor wire.


3. DISCONNECT FRONT STABILIZER LINK ASSEMBLY LH

  1. F049984E01
    Remove the nut and disconnect the stabilizer link from the steering knuckle.

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.


4. REMOVE FRONT UPPER SUSPENSION ARM ASSEMBLY LH

F049998E01
  1. Support the lower arm with a jack.

  1. Remove the clip and nut.

  1. Using SST, disconnect the upper ball joint from the steering knuckle.

    SST
    09628-62011  

  1. F050000E01
    Remove the nut, 2 retainers and bolt.

  1. Remove the upper arm.


5. REMOVE FRONT UPPER ARM BUSH

  1. F050001E01
    Using a hammer and chisel, strike and bend the entire flange of the bush as shown in the illustration.

  1. F050002E03
    Using SST and a press, press out the upper arm bush.
    Text in Illustration 
    *1
    Bush
    SST
    09613-26010  
    09710-22021   (09710-01041)
    09950-00020  


6. REMOVE UPPER BALL JOINT DUST COVER
  1. Remove the dust cover set ring and dust cover from the upper arm.

    NOTICE:
    1. Do not damage the ball joint dust cover.
    2. If the ball joint dust cover is damaged, replace it.


7. REMOVE FRONT UPPER BALL JOINT

  1. C237895
    Using a snap ring expander, remove the snap ring.

  1. C237642E01
    Using SST and a press, press out the upper ball joint.
    SST
    09612-30012  
    09388-40010  

← ON-VEHICLE INSPECTION (from Jun 2011)INSPECTION (from Jun 2011) →