2014 Hilux · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built Apr 2012 – Jul 2012

Versions by build date: Jun 2011 – Oct 2011 Nov 2011 – Mar 2012 Apr 2012 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. INSTALL FRONT UPPER BALL JOINT

  1. C237853E01
    Using SST and a press, press in a new upper ball joint.
    SST
    09612-30012  
    09223-00010  

  1. Using a snap ring expander, install a new snap ring.

    NOTICE:
    Make sure the snap ring is securely installed in the groove.


2. INSTALL UPPER BALL JOINT DUST COVER

  1. C159213E05
    Pack the upper ball joint with MP grease No. 2.
    Text in Illustration 
    *1
    MP Grease No. 2

    Grease capacity:
    8.0 g (0.282 oz.)

  1. Apply MP grease No. 2 to the locations shown in the illustration.

    NOTICE:
    Do not apply MP grease No. 2 to the tapered or threaded parts of the ball joint.

  1. Install a new dust cover to the upper arm.

  1. Install a new dust cover set ring.


3. INSTALL FRONT UPPER SUSPENSION ARM BUSH

  1. F049921E01
    Using SST and a press, press in a new upper arm bush.
    SST
    09710-22021   (09710-01031)


4. TEMPORARILY INSTALL FRONT UPPER SUSPENSION ARM ASSEMBLY LH

F049917E01
  1. Temporarily install the upper arm with the 2 bolts and 2 nuts.

    HINT:
    Fix the nuts in place and temporarily install the bolts.

  1. Install the upper arm to the front axle with the nut.

    Torque:
    110 N*m{ 1122 kgf*cm , 81 ft.*lbf }

  1. Install a new clip.


5. CONNECT FRONT FLEXIBLE HOSE
  1. Connect the front flexible hose with the bolt.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }


6. INSTALL FRONT WHEEL

Torque:
152 N*m{ 1,550 kgf*cm , 112 ft.*lbf } for steel type
121 N*m{ 1,234 kgf*cm , 89 ft.*lbf } for aluminum type


7. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several times to stabilize the suspension.


8. TIGHTEN FRONT UPPER SUSPENSION ARM ASSEMBLY LH
  1. Tighten the 2 bolts of the upper arm.

    Torque:
    85 N*m{ 867 kgf*cm , 63 ft.*lbf }


9. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)
← INSTALLATION (Nov 2011 – Mar 2012)INSTALLATION (Aug 2012 – Jul 2013) →