2014 Hilux · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Jun 2011

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE FRONT WHEEL

2. DISCONNECT FRONT FLEXIBLE HOSE

  1. C237858
    Remove the bolt and disconnect the front flexible hose.


3. REMOVE FRONT UPPER SUSPENSION ARM ASSEMBLY LH

  1. C237859
    Support the front axle with a jack.

  1. Remove the clip and nut.

  1. F049916E01
    Using SST, disconnect the upper ball joint from the steering knuckle.
    SST
    09628-62011  

  1. F049917E01
    Remove the 2 nuts and 2 bolts.

  1. Remove the upper arm.


4. REMOVE FRONT UPPER SUSPENSION ARM BUSH

  1. F049918E01
    Using a hammer and chisel, strike and bend the entire flange of the upper arm bush as shown in the illustration.

  1. F049919E02
    Using SST and a press, press out the upper arm bush.
    Text in Illustration 
    *1
    Bush
    SST
    09613-26010  
    09710-22021   (09710-01061)
    09950-00020  


5. REMOVE UPPER BALL JOINT DUST COVER
  1. Remove the dust cover set ring and dust cover from the upper arm.

    NOTICE:
    1. Do not damage the ball joint dust cover.
    2. If the ball joint dust cover is damaged, replace it.


6. REMOVE FRONT UPPER BALL JOINT

  1. C237639
    Using a snap ring expander, remove the snap ring.

  1. C237640E01
    Using SST and a press, press out the upper ball joint.
    SST
    09612-30012  
    09388-40010  

← ON-VEHICLE INSPECTION (from Jun 2011)INSPECTION (from Jun 2011) →