INSTALLATION
Removal / installation · Vehicles built from Jun 2011
| 1. INSTALL FRONT STABILIZER BAR |
Install the stabilizer bar front to the vehicle body.
| 2. INSTALL FRONT NO. 1 STABILIZER BAR BUSH |
![]() ![]() |
Install the 2 bushes.
- HINT:
- Install each bush to the outer side of the bush stopper on the stabilizer bar.
- Install each bush to the outer side of the bush stopper on the stabilizer bar.
- Install each bush with the slit of the bush facing the vehicle front side.
- Install each bush with the slit of the bush facing the vehicle front side.
| 3. INSTALL FRONT STABILIZER BRACKET |
![]() ![]() |
Install the 2 brackets with the 4 bolts.
- Torque:
- 48 N*m{ 489 kgf*cm , 35 ft.*lbf }
- HINT:
- 2WD and 4WD and Pre-runner vehicle stabilizer brackets are imprinted with arrows. Only the 4WD and Pre-runner brackets' arrows must point toward the front of the vehicle.
| 4. INSTALL FRONT STABILIZER LINK ASSEMBLY LH |
![]() ![]() |
2WD:
Install the front stabilizer link assembly LH with a new nut (upper side) and the nut (lower side).
- Torque:
- 27 N*m{ 316 kgf*cm , 23 ft.*lbf } for upper side
- 78 N*m{ 795 kgf*cm , 58 ft.*lbf } for lower side
- HINT:
- If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.
4WD and Pre-runner:
Install the front stabilizer link assembly LH with the 2 nuts.
- Torque:
- 70 N*m{ 714 kgf*cm , 52 ft.*lbf }
- HINT:
- If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.
| 5. INSTALL FRONT STABILIZER LINK ASSEMBLY RH |
- HINT:
- Use the same procedures described for the LH side.
| 6. INSTALL FRONT WHEEL |
Install the front wheel.
- Torque:
- 2WD:
- 152 N*m{ 1,550 kgf*cm , 112 ft.*lbf } for steel wheel
- 121 N*m{ 1,234 kgf*cm , 89 ft.*lbf } for aluminum wheel
- 4WD and Pre-runner:
- 105 N*m{ 1,071 kgf*cm , 77 ft.*lbf }




