2014 Hilux · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Jun 2011

HINT:
  1. Use the same procedures for the RH side and LH side.
  1. The procedures listed below are for the LH side.
  1. A bolt without a torque specification is shown in the standard bolt chart.


1. REMOVE FRONT WHEEL

2. REMOVE FRONT STABILIZER LINK ASSEMBLY LH

F050281E02
  1. Remove the 2 nuts and stabilizer link.

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.


3. REMOVE FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


4. REMOVE FRONT STABILIZER BRACKET

F050282E02
  1. Remove the 4 bolts and 2 brackets.


5. REMOVE FRONT NO. 1 STABILIZER BAR BUSH
  1. Remove the 2 bushes.


6. REMOVE FRONT STABILIZER BAR
  1. Remove the stabilizer bar front from the vehicle body.

← COMPONENTS (from Jun 2011)INSPECTION (from Jun 2011) →