2014 Hilux · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Jun 2011

HINT:
  1. Use the same procedures for the RH side and LH side.
  1. The procedures listed below are for the LH side.
  1. A bolt without a torque specification is shown in the standard bolt chart.


1. REMOVE REAR WHEEL

2. REMOVE REAR SHOCK ABSORBER ASSEMBLY

F050332E03
  1. Support the rear axle housing.

    1. Jack up and support the vehicle's frame on stands.

    2. Lower the axle housing until the leaf spring tension is free, and maintain this position.

  1. Remove the 2 bolts and 2 washers.

  1. Disconnect the absorber (with the 4 bushes) from the U bolt seat and frame.

  1. Remove the 4 bushes from the absorber.

  1. Remove the 2 washers.

← COMPONENTS (from Jun 2011)INSPECTION (from Jun 2011) →