INSTALLATION
Removal / installation · Vehicles built from Jun 2011
| 1. INSTALL REAR LEAF SPRING ASSEMBLY LH |
Install the spring to the vehicle body.
| 2. INSTALL NO. 2 REAR LEAF SPRING SHACKLE SUB-ASSEMBLY |
Install the spring shackle to the spring and vehicle body.
| 3. TEMPORARILY INSTALL SHACKLE INNER PLATE |
Temporarily install the inner plate to the shackle No. 2 with the 2 washers and 2 nuts.
- HINT:
- After stabilizing the suspension, torque the nut.
| 4. TEMPORARILY INSTALL REAR LEAF SPRING PIN BOLT |
Temporarily install the pin bolt with the washer and nut.
- HINT:
- The pin bolt can be installed from either side of the spring.
- After stabilizing the suspension, torque the nut.
- The pin bolt can be installed from either side of the spring.
| 5. TEMPORARILY INSTALL REAR SPRING U BOLT |
![]() ![]() |
Temporarily install the U bolt seat and spring bumper with the 2 U bolts, 4 washers and 4 nuts.
- HINT:
- When tightening the U bolts, tighten the nuts in diagonal pairs.
| 6. INSTALL REAR SHOCK ABSORBER ASSEMBLY |
![]() ![]() |
Install the 2 washers to the axle housing.
Install 4 new bushes to the absorber.
Install the absorber (with the 4 bushes) to the U bolt seat and frame.
Install the 2 washers.
Temporarily tighten the 2 bolts.
| 7. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY |


| *1 |
No. 3 Parking Brake Cable |
*2 |
No. 3 Clip |
Install the No. 3 parking brake cable with the 3 bolts and nut.
- Torque:
- for Bolt A, Nut C:
- 26 N*m{ 260 kgf*cm , 19 ft.*lbf }
- for Bolt B:
- 14 N*m{ 143 kgf*cm , 10 ft.*lbf }
Install the No. 3 clip.
Connect the No. 3 parking brake cable to the parking brake shoe lever LH and backing plate LH.
Connect the No. 3 parking brake cable to the backing plate with the 2 bolts.
- Torque:
- 9.0 N*m{ 92 kgf*cm , 80 in.*lbf }
Connect the No. 3 parking brake cable to the parking brake shoe lever (Click here).
| 8. STABILIZE SUSPENSION |
Lower the vehicle.
Press down on the vehicle several times to stabilize the suspension.
| 9. TIGHTEN SPRING SHACKLE INNER PLATE NUT |
Tighten the inner plate with the 2 nuts.
- Torque:
- 60 N*m{ 612 kgf*cm , 44 ft.*lbf }
| 10. TIGHTEN REAR SPRING PIN NUT |
Tighten the pin nut.
- Torque:
- 120 N*m{ 1224 kgf*cm , 89 ft.*lbf }
| 11. TIGHTEN SPRING U BOLT SEAT NUT |
Tighten the set nut.
- Torque:
- 120 N*m{ 1224 kgf*cm , 89 ft.*lbf }
| 12. INSTALL REAR WHEEL |
Install the wheel.
- Torque:
- 105 N*m{ 1070 kgf*cm , 77 ft.*lbf }


