2014 Hilux · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built Jun 2011 – Jul 2013

Versions by build date: Jun 2011 – Jul 2013 from Aug 2013


1. INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY
  1. Install the clutch release cylinder with the 2 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }


2. CONNECT CLUTCH RELEASE CYLINDER FLEXIBLE TUBE
  1. Using a union nut wrench, connect the flexible tube.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).


3. BLEED AIR FROM CLUTCH PIPE LINE
(Click here)

4. CHECK FOR CLUTCH FLUID LEAKAGE

5. CHECK FLUID LEVEL IN RESERVOIR

Fluid:
Made
Fluid
for TSAM Made
SAE J1704 or FMVSS No. 116 DOT 4
except TSAM Made
SAE J1703 or FMVSS No. 116 DOT 3

← REASSEMBLY (from Jun 2011)INSTALLATION (from Aug 2013) →