2014 Hilux · Service Manual BODY ELECTRICAL

No Answer-Back

Circuit diagnosis · Vehicles built Jun 2011 – Jul 2013

Versions by build date: Jun 2011 – Jul 2013 from Aug 2013

DESCRIPTION

In this case, wireless control functions are normal but the hazard warning light and side turn signal light answer-back is not normal (the driver side junction block assembly's turn signal flasher assembly output may be malfunctioning).

WIRING DIAGRAM

B276306E04

INSPECTION PROCEDURE


1. CHECK HAZARD WARNING LIGHT OPERATION
  1. Check that the hazard warning lights and side turn signal lights flash when the hazard warning signal switch is pressed.

    OK:
    Hazard warning lights flash when hazard warning signal switch is pressed.



NG
Go to LIGHTING SYSTEM (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (DRIVER SIDE JUNCTION BLOCK - TURN SIGNAL FLASHER)
  1. Disconnect the 2O driver side junction block assembly connector.

  1. Disconnect the T22 turn signal flasher assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    2O-25 (HAZ) - T22-8 (HAZ)
    Always
    Below 1 Ω
    2O-25 (HAZ) or T22-8 (HAZ) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY


← Only Wireless Control Function is Inoperative (from Aug 2013)No Answer-Back (from Aug 2013) →