INSTALLATION
Removal / installation · Vehicles built from Jun 2011
| 1. INSTALL INPUT SHAFT FRONT BEARING |
![]() ![]() |
Using SST and a press, press in a new front bearing.
- SST
- 09316-60011
Select a snap ring that will allow minimal axial play.

- Standard clearance:
- 0.10 mm (0.0039 in.) or less
- Front bearing shaft snap ring thickness:
Mark
Thickness
0
2.05 to 2.10 mm (0.0807 to 0.0827 in.)
1
2.10 to 2.15 mm (0.0827 to 0.0847 in.)
2
2.15 to 2.20 mm (0.0847 to 0.0866 in.)
3
2.20 to 2.25 mm (0.0866 to 0.0886 in.)
4
2.25 to 2.30 mm (0.0886 to 0.0906 in.)
5
2.30 to 2.35 mm (0.0906 to 0.0925 in.)
Using a snap ring expander, install the snap ring.

| 2. INSTALL INPUT SHAFT BEARING |
![]() ![]() |
Coat the 13 input shaft bearings with MP grease, and install them to the input shaft.
| 3. INSTALL NO. 2 SYNCHRONIZER RING |
![]() ![]() |
Coat the No. 2 synchronizer ring with gear oil, and install it to the input shaft.



