2014 Hilux · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built from Jun 2011


1. INSTALL COUNTER GEAR FRONT BEARING

C086513E01
  1. Using SST and a press, press in a new front bearing to the counter gear.

    SST
    09515-10010  

  1. C086514E01
    Select a snap ring that will allow minimum axial play.

    Standard clearance:
    0.1 mm (0.0039 in.) or less

    Standard No. 2 counter gear front bearing snap ring thickness:
    Mark
    Thickness
    1
    2.05 to 2.10 mm (0.0807 to 0.0827 in.)
    2
    2.10 to 2.15 mm (0.0827 to 0.0847 in.)
    3
    2.15 to 2.20 mm (0.0847 to 0.0866 in.)
    4
    2.20 to 2.25 mm (0.0866 to 0.0886 in.)
    5
    2.25 to 2.30 mm (0.0886 to 0.0906 in.)
    6
    2.30 to 2.35 mm (0.0906 to 0.0925 in.)

  1. C086511E01
    Using a snap ring expander, install the snap ring.


2. INSTALL NO. 3 TRANSMISSION HUB SLEEVE

D033572E01
  1. Coat the 5th gear with gear oil.

  1. Install the No. 3 hub sleeve and 2 No. 3 synchromesh shifting keys to the 5th gear.

    HINT:
    Be sure to set the No. 3 hub sleeve and No. 3 synchromesh shifting keys to the 5th gear in the correct direction.

  1. Install the key spring (C spring) and key spring (return spring) to the 5th gear.

  1. D033581E01
    Using a snap ring expander, install the snap ring to the 5th gear.


3. INSTALL COUNTER 5TH GEAR BEARING

D033580E01
  1. Coat the 5th gear bearing with gear oil, and install it to the 5th gear.


4. INSPECT COUNTER SHAFT 5TH GEAR RADIAL CLEARANCE

C086503E01
  1. Install the 5th gear thrust washer lock ball, 5th gear thrust washer and counter shaft 5th gear to the counter gear.

  1. Using a dial indicator, measure the 5th gear radial clearance.

    Standard clearance:
    0.008 to 0.034 mm (0.0003 to 0.0013 in.)

    1. If the clearance is not as specified, replace the counter 5th gear bearing.

← REMOVAL (from Jun 2011)PROBLEM SYMPTOMS TABLE (from Jun 2011) →