2014 Hilux · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jun 2011


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. DISCONNECT AIR CLEANER HOSE
  1. Disconnect the IAT sensor connector.

  1. Detach the clamp of the IAT sensor harness.

  1. Loosen the 2 clamps from the air cleaner hose.

  1. Remove the air cleaner hose.


3. REMOVE INTAKE PIPE ASSEMBLY

  1. A114290
    Remove the 2 bolts and loosen the hose clamp.


4. REMOVE VENTURI

  1. A111052E02
    Disconnect the throttle open switch connector.

  1. A111053E02
    Disconnect the throttle control motor connector.

  1. Remove the venturi and gasket.


5. REMOVE INJECTION PIPE SET

  1. A121940
    Using a union nut wrench, loosen the 8 union nuts of the 4 injection pipes.

  1. Remove the 2 nuts, 2 upper pipe clamps and 4 injection pipes with lower pipe clamps.


6. REMOVE NO. 1 GLOW PLUG CONNECTOR
  1. Remove the nut and wire harness.

  1. Remove the 4 screw grommets, 4 nuts and glow plug connector.


7. REMOVE NOZZLE LEAKAGE PIPE ASSEMBLY

  1. A121941
    Disconnect the fuel hose from the leakage pipe.

  1. Remove the 4 nuts, leakage pipe and 4 ring packing washers.


8. REMOVE NOZZLE HOLDER AND NOZZLE SET

  1. A121942E01
    Using SST, remove the 4 injection nozzles, 4 injection nozzle seats and 4 injection nozzle seat gaskets.
    SST
    09268-64010   (09268-64020)

← COMPONENTS (from Jun 2011)DISASSEMBLY (from Jun 2011) →