ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jun 2011
| CHECK TURN SIGNAL FLASHER RELAY |
Disconnect the T22 relay connector.
Measure the voltage of the wire harness side connector.


Standard voltage: Tester Connection
Condition
Specified Condition
T22-1 (IG) - Body ground
Ignition switch OFF
Below 1 V
T22-1 (IG) - Body ground
Ignition switch ON
10 to 14 V
T22-4 (B) - Body ground
Always
10 to 14 V
T22-7 (E) - Body ground
Always
Below 1 V
- If the result is not as specified, there may be a malfunction on the wire harness side.
- If the result is not as specified, there may be a malfunction on the wire harness side.
Reconnect the T22 relay connector.
Measure the voltage of the connector.
Standard voltage: Tester Connection
Condition
Specified Condition
T22-2 (LR) - Body ground
Hazard warning switch OFF
Below 1 V
T22-2 (LR) - Body ground
Hazard warning switch OFF
10 to 14 V (60 to 120 times per minute)
T22-2 (LR) - Body ground
Ignition switch ON and turn signal switch (right turn) OFF
Below 1 V
T22-2 (LR) - Body ground
Ignition switch ON and turn signal switch (right turn) ON
10 to 14 V (60 to 120 times per minute)
T22-3 (LL) - Body ground
Hazard warning switch OFF
Below 1 V
T22-3 (LL) - Body ground
Hazard warning switch ON
10 to 14 V (60 to 120 times per minute)
T22-3 (LL) - Body ground
Ignition switch ON and turn signal switch (left turn) OFF
Below 1 V
T22-3 (LL) - Body ground
Ignition switch ON and turn signal switch (left turn) ON
10 to 14 V (60 to 120 times per minute)
T22-5 (EL) - Body ground
Ignition switch ON and turn signal switch (left turn) OFF
10 to 14 V
T22-5 (EL) - Body ground
Ignition switch ON and turn signal switch (left turn) ON
Below 1 V
T22-6 (ER) - Body ground
Ignition switch ON and turn signal switch (right turn) OFF
10 to 14 V
T22-4 (ER) - Body ground
Ignition switch ON and turn signal switch (right turn) ON
Below 1 V
T22-8 (HAZ) - Body ground
Hazard warning switch OFF
10 to 14 V
T22-8 (HAZ) - Body ground
Hazard warning switch ON
Below 1 V
