REMOVAL
Removal / installation · Vehicles built from Jun 2011
- HINT:
- Use the same procedures for the RH and LH sides.
- The procedures listed below are for the LH side.
- Use the same procedures for the RH and LH sides.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH |
![]() ![]() |
Detach the 2 claws and remove the light as shown in the illustration.
Disconnect the connector and remove the side turn signal light.
| 3. REMOVE SIDE TURN SIGNAL LIGHT BULB |
![]() ![]() |
Turn the bulb/socket unit in the direction indicated by the arrow and pull to remove it.
Remove the bulb from the socket.



