2014 Hilux · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Jun 2011

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH
  1. Attach the claw.

  1. Attach the guide to install the rear combination light socket and wire sub-assembly LH.


2. INSTALL BACK UP LIGHT BULB

  1. E225356
    Install the back up light bulb to the rear combination light socket and wire sub-assembly LH.

  1. Turn the rear combination light socket and wire subassembly LH in the direction indicated by the arrow in the illustration to install it.


3. INSTALL REAR TURN SIGNAL LIGHT BULB

  1. E225357
    Install the rear turn signal light bulb to the rear combination light socket and wire sub-assembly LH.

  1. Turn the rear combination light socket and wire subassembly LH in the direction indicated by the arrow in the illustration to install it.


4. INSTALL TAIL AND STOP LIGHT BULB

  1. E225358
    Install the tail and stop light bulb to the rear combination light socket and wire sub-assembly LH.

  1. Turn the rear combination light socket and wire subassembly LH in the direction indicated by the arrow in the illustration to install it.


5. INSTALL REAR COMBINATION LIGHT ASSEMBLY
  1. Connect the connector.

  1. Attach the 2 clips to install the rear combination light assembly LH.

  1. Install the 2 bolts to the rear combination light assembly LH.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

← REMOVAL (from Jun 2011)COMPONENTS (from Jun 2011) →