REMOVAL
Removal / installation · Vehicles built from Jun 2011
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE NO. 1 ROOM LIGHT ASSEMBLY |
Using a screwdriver, detach the 4 claws and remove the lens.

- HINT:
- Tape the screwdriver tip before use.
Remove the 2 screws and room light.

Disconnect the lamp connector.
| 3. REMOVE NO. 1 ROOM LIGHT BULB |
Remove the bulb from the room light.
