REMOVAL
Removal / installation · Vehicles built from Jun 2011
- HINT:
- Use the same procedures for the RH and LH sides.
- The procedures listed below are for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart (Click here).
- Use the same procedures for the RH and LH sides.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY |
![]() ![]() |
Remove the bolt and switch.
Disconnect the connector.


