1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2.
REMOVE FRONT WIPER ARM HEAD CAP
Remove the 2 caps.
3.
REMOVE FRONT WIPER ARM & BLADE ASSEMBLY LH
Remove the nut and arm & blade.
4.
REMOVE FRONT WIPER ARM & BLADE ASSEMBLY RH
Remove the nut and arm & blade.
5.
REMOVE HOOD TO COWL TOP SEAL
Detach the 9 clips and remove the seal.
6.
REMOVE COWL TOP VENTILATOR LOUVER LH
Detach the 4 claws and remove the louver.
7.
REMOVE COWL TOP VENTILATOR LOUVER RH
Detach the 5 claws and remove the louver.
8.
REMOVE WINDSHIELD WIPER MOTOR & LINK ASSEMBLY
Disconnect the connector.
Remove the 2 bolts.
Move the wiper cushion in the direction shown by the arrow in the illustration to detach the wiper cushion from the body, and remove the wiper motor & link.
9.
REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
Using a screwdriver, disconnect the 2 rods of the wiper link from the wiper motor as shown in the illustration.
HINT:
Tape the screwdriver tip before use.
Using a T30 ''torx'' socket, remove the 2 bolts and wiper motor.