2014 Hilux · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Jun 2011


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE CONSOLE BOX ASSEMBLY
(Click here)

3. REMOVE SHIFT LEVER BOOT ASSEMBLY

G034544E02
  1. w/o Console Box:
    Remove the front seat, front door scuff plate, etc. and fold back the floor carpet so that the shift lever can be removed.

  1. Remove the 4 screws, 2 clips and shift lever boot.


4. REMOVE FLOOR SHIFT SHIFT LEVER ASSEMBLY

G021695E02
  1. Cover the shift lever cap with a cloth.

  1. Press down on the shift lever cap and rotate it counterclockwise to remove it.

  1. Pull out the shift lever.


5. REMOVE TRANSFER HIGH AND LOW SHIFT LEVER ASSEMBLY

G021696E02
  1. Using needle nose pliers, remove the snap ring and pull out the shift lever.

    HINT:
    Move the transfer shift lever to the H4 position.


6. REMOVE TRANSFER CASE LOWER PROTECTOR
  1. Remove the 4 bolts and transfer case lower protector.


7. REMOVE NO. 1 ENGINE UNDER COVER

8. REMOVE NO. 2 ENGINE UNDER COVER

9. DRAIN MANUAL TRANSMISSION OIL
  1. Remove the drain plug and gasket to drain the oil.

  1. Install a new gasket and the drain plug.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }


10. REMOVE REAR PROPELLER SHAFT ASSEMBLY
(Click here)

11. REMOVE FRONT PROPELLER SHAFT ASSEMBLY
(Click here)

12. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(Click here)

13. DISCONNECT WIRE HARNESS
  1. Transmission side:
    Disconnect the back-up light switch connector.

  1. Transfer side:
    Disconnect the No. 1, No. 2 and No. 3 transfer indicator switch connectors, and vehicle speed sensor connector.


14. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

G034223E01
  1. Remove the 2 bolts and disconnect the release cylinder.


15. REMOVE STARTER ASSEMBLY
(Click here)

16. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY

B085193E05
  1. Support the transmission rear side with a support stand.

  1. Remove the 4 set bolts of the rear No. 1 engine mounting insulator.

  1. Remove the 4 bolts, 4 nuts and frame crossmember.


17. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR

G034219E03
  1. Remove the 4 bolts and engine mounting insulator.


18. REMOVE STIFFENER PLATE

C121621E03
  1. Remove the 4 bolts and stiffener plate RH.

  1. Remove the 4 bolts and stiffener plate LH.


19. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY

C112945E04
  1. Using a transmission jack, support the transmission.

  1. Remove the support stand from the rear side.

  1. Remove the 4 bolts and transmission.


20. REMOVE TRANSFER ASSEMBLY
(Click here)
← COMPONENTS (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2012) →