2014 Hilux · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 from Aug 2012


1. INSTALL INPUT SHAFT FRONT BEARING

D029020E01
  1. Using SST and a press, press in a new front bearing to the input shaft.

    SST
    09950-60010   (09951-00570)
    09950-70010   (09951-07100)

    NOTICE:
    Set the snap ring groove of the input shaft front bearing to the front side.


2. INSTALL FRONT BEARING SHAFT SNAP RING
  1. Select a snap ring that makes the clearance between the input shaft and front bearing within the specification.

    Standard clearance:
    0.10 mm (0.0039 in.) or less

    Mark
    Thickness
    A
    2.10 to 2.15 mm (0.0827 to 0.0846 in.)
    B
    2.15 to 2.20 mm (0.0846 to 0.0866 in.)
    C
    2.20 to 2.25 mm (0.0866 to 0.0886 in.)
    D
    2.25 to 2.30 mm (0.0886 to 0.0906 in.)
    E
    2.30 to 2.35 mm (0.0906 to 0.0925 in.)
    F
    2.35 to 2.40 mm (0.0925 to 0.0945 in.)
    G
    2.40 to 2.45 mm (0.0945 to 0.0965 in.)

  1. D026115E02
    Using a snap ring expander, install the snap ring.


3. INSTALL INPUT SHAFT BEARING

  1. D026114E02
    Apply gear oil to the input shaft bearing, and install it to the input shaft.


4. INSTALL NO. 2 SYNCHRONIZER RING

  1. D026113E02
    Apply gear oil to No. 2 synchronizer ring, and install it to the input shaft.

← REMOVAL (from Jun 2011)INSTALLATION (from Aug 2012) →