2014 Hilux · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Jun 2011


1. REMOVE NO. 2 SYNCHRONIZER RING

D026113E01
  1. Remove synchronizer ring from the input shaft.


2. REMOVE INPUT SHAFT BEARING

D026114E01
  1. Remove the bearing from the input shaft.


3. REMOVE FRONT BEARING SHAFT SNAP RING

D026115E01
  1. Using a snap ring expander, remove the snap ring from the input shaft.


4. REMOVE INPUT SHAFT FRONT BEARING

D026116E01
  1. Using SST and a press, press out the front bearing from the input shaft.

    SST
    09950-00020  


5. INSPECT NO. 2 SYNCHRONIZER RING

G037541E01
  1. Apply gear oil to the cone of the input shaft, and check that it does not turn in both direction while pushing the No. 2 synchronizer ring.
    If it can turn, replace the No. 1 synchronizer ring.

  1. D026118E01
    Push the No. 2 synchronizer ring to the cone of the input shaft. Measure the clearance between the No. 2 synchronizer ring and input shaft.

    Standard clearance:
    0.70 to 1.70 mm (0.0276 to 0.0669 in.)

    If the clearance is not as specified, replace the No. 2 synchronizer ring with a new one.

← COMPONENTS (from Jun 2011)INSTALLATION (Jun 2011 – Jul 2012) →