C0278/11 Open in ABS Solenoid Relay Circuit
Diagnostic trouble codes · Vehicles built from Jun 2011
Also covers:
- C0279/12 Short to B+ in ABS Solenoid Relay Circuit
DESCRIPTION
This relay supplies power to each ABS solenoid. After the ignition switch is turned ON, if the ABS initial check completes, the skid control ECU turns the ABS solenoid relay on.| DTC No. |
DTC Detection Condition |
Trouble Area |
| C0278/11 |
When either of following is detected: 1. Both conditions continue for at least 0.2 seconds
|
|
| C0279/12 |
When relay is OFF, turning ignition switch ON closes relay contact immediately and continues for at least 0.2 seconds |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT FUSE (ALT, ABS NO. 2) |
Remove the ALT and ABS NO. 2 H-fuses from the engine room junction block.
Measure the resistance of the H-fuses.
- Standard resistance:
- Below 1 Ω
|
|
||||
| OK | |
| 2. CHECK WIRE HARNESS (SKID CONTROL ECU - BATTERY AND BODY GROUND) |
![]() ![]() |
Disconnect the S2 ECU connector.
Measure the voltage of the wire harness side connector.
- Standard voltage:
Tester Connection
Specified Condition
S2-1 (+BS) - Body ground
10 to 14 V
Measure the resistance of the wire harness side connector.
- Standard resistance:
Tester Connection
Specified Condition
S2-2 (GND1) - Body ground
Below 1 Ω
S2-24 (GND2) - Body ground
Below 1 Ω
|
|
||||
| OK | |
| 3. RECONFIRM DTC |
As the ABS motor relay is built into the brake actuator assembly, ABS motor relay and solenoid unit inspection cannot be performed.
Be sure to check if the DTC is output before replacing the brake actuator assembly.
Clear the DTCs.
Drive the vehicle at 6 km/h (4 mph) or more.
Check for DTCs.
Result Result
Proceed to
DTC is output
A
DTC is not output
B
|
|
||||
| A | ||
| ||

