2014 Hilux · Service Manual BODY ELECTRICAL

Engine Coolant Temperature Gauge Malfunction

Circuit diagnosis · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

DESCRIPTION

In this circuit, the meter CPU receives engine coolant temperature signals from the ECM. The meter CPU displays engine coolant temperature that is calculated based on the data received from the ECM.

WIRING DIAGRAM

E261910E06
E261910E07
E261910E08
E261910E09
E261910E10

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. *1: for 1KD-FTV, 2KD-FTV, 5L-E
  2. *2: for 1TR-FE, 2TR-FE, 1GR-FE
  1. Check for DTCs of the ECD system*1 or SFI system*2.

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for 1KD-FTV, 2KD-FTV, 5L-E)
    B
    DTC is output (for 1TR-FE, 2TR-FE, 1GR-FE)
    C



B
GO TO ECD SYSTEM

C
GO TO SFI SYSTEM
A


2. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)
  1. *1: for 1KD-FTV, 2KD-FTV
  2. *2: for 2TR-FE
  3. *3: for 1GR-FE
  4. *4: for 5L-E
  1. Disconnect the C25 combination meter assembly connector.

  1. Disconnect the E5*1 or E10*2 or E13*3 or E20*4 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard Resistance:
    for 1KD-FTV w/o DPF, 2KD-FTV w/o DPF 
    Tester Connection
    Condition
    Specified Condition
    C25-4 (TEMP) - E5-2 (THWO)
    Always
    Below 1 Ω
    C25-4 (TEMP) or E5-2 (THWO) - Body ground
    Always
    10 kΩ or higher
    for 1KD-FTV w/ DPF, 2KD-FTV w/ DPF 
    Tester Connection
    Condition
    Specified Condition
    C25-4 (TEMP) - E30-16 (THWO)
    Always
    Below 1 Ω
    C25-4 (TEMP) or E30-16 (THWO) - Body ground
    Always
    10 kΩ or higher
    for 1TR-FE, 2TR-FE 
    Tester Connection
    Condition
    Specified Condition
    C25-4 (TEMP) - E10-14 (THWO)
    Always
    Below 1 Ω
    C25-4 (TEMP) or E10-14 (THWO) - Body ground
    Always
    10 kΩ or higher
    for 1GR-FE 
    Tester Connection
    Condition
    Specified Condition
    C25-4 (TEMP) - E13-14 (THWO)
    Always
    Below 1 Ω
    C25-4 (TEMP) or E13-14 (THWO) - Body ground
    Always
    10 kΩ or higher
    for 5L-E 
    Tester Connection
    Condition
    Specified Condition
    C25-4 (TEMP) - E20-8 (THWO)
    Always
    Below 1 Ω
    C25-4 (TEMP) or E20-8 (THWO) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. REPLACE COMBINATION METER ASSEMBLY
  1. Replace the combination meter assembly with a new or normally functioning one (Click here).

    OK:
    The operation of the engine coolant temperature gauge returns to normal.



NG
REPLACE ECM
OK

END (COMBINATION METER ASSEMBLY IS DEFECTIVE)


← Engine Coolant Temperature Gauge Malfunction (Jun 2011 – Jul 2012)Engine Coolant Temperature Gauge Malfunction (from Aug 2013) →