REMOVAL
Removal / installation · Vehicles built from Jun 2011
- CAUTION:
- Wear protective gloves when removing the exhaust pipe.
- Wear protective gloves when removing the exhaust pipe.
- The exhaust pipe is extremely hot immediately after the engine has stopped.
- The exhaust pipe is extremely hot immediately after the engine has stopped.
- Confirm that the exhaust pipe has cooled down before removing it.
- Confirm that the exhaust pipe has cooled down before removing it.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) |
![]() ![]() |
Disconnect the sensor connector.
Using SST, remove the sensor from the front exhaust pipe.
- SST
- 09224-00010
| 3. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) |
![]() ![]() |
Using SST, install the sensor to the front exhaust pipe.
- SST
- 09224-00010
- Torque:
- 40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST
- 44 N*m{ 449 kgf*cm , 32 ft.*lbf } for use without SST
- HINT:
- Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
Connect the sensor connector.
| 4. REMOVE TAILPIPE ASSEMBLY |
Remove the 2 bolts, exhaust pipe support and tailpipe
| 5. REMOVE CENTER EXHAUST PIPE ASSEMBLY |
Remove the 2 bolts and 2 compression springs.
Remove the 3 exhaust pipe supports and exhaust pipe.
| 6. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY |
Remove the 2 bolts, 2 nuts, pipe support and exhaust pipe.
| 7. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
Remove the 2 nuts, pipe support and exhaust pipe.



