2014 Hilux · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE FRONT SEAT ASSEMBLY (for Separate Seat Type)

B087764E01
  1. Using a moulding remover, detach the 2 claws and remove the outer seat track bracket cover.


3. REMOVE FRONT SEAT ASSEMBLY (for Bench Seat Type)

  1. B122861E01
    Pull the inner belts out from the bottom of the seat cushion.

  1. Remove the 4 bolts.

  1. w/ Occupant detection sensor:
    Disconnect the connector under the seat.

  1. Remove the seat.

    NOTICE:
    Be careful not to damage the vehicle body.


4. REMOVE FRONT SEAT INNER BELT ASSEMBLY

B087811E01
  1. w/ Driver seat belt warning light:
    Detach the clamp.

  1. B089297E01
    w/ Driver seat belt warning light:
    Detach the wire harness from the clamp.

  1. Remove the nut and seat belt.

  1. Remove the buckle cover.


5. REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Separate Seat Type)

B113100E01
  1. w/ Passenger seat belt warning light:
    Detach the 2 clamps.

  1. w/ Passenger seat belt warning light:
    Disconnect the connector.

  1. B087812E02
    Detach the wire harness from the clamp.

  1. Remove the nut and seat belt.

  1. Remove the buckle cover.


6. REMOVE FRONT SEAT INNER W/ CENTER BELT ASSEMBLY RH (for Bench Seat Type)

B113102
  1. Remove the nut and seat belt.


7. REMOVE FRONT SEAT INNER W/ CENTER BELT ASSEMBLY LH (for Bench Seat Type)

B115781
  1. Remove the bolt and seat belt.

← COMPONENTS (from Aug 2013)REMOVAL (Aug 2012 – Jul 2013) →