2014 Hilux · Service Manual BODY ELECTRICAL

Radio Receiver Power Source Circuit

Circuit diagnosis · Vehicles built Nov 2011 – Jul 2012

Versions by build date: Jun 2011 – Oct 2011 Nov 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

DESCRIPTION

This circuit provides power to the radio receiver assembly.

WIRING DIAGRAM

C240172E15

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - BATTERY AND BODY GROUND)

  1. E178447E23
    Disconnect the R1 radio receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R1-7 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    R1-4 (B) - Body ground
    Always
    11 to 14 V
    R1-3 (ACC) - Body ground
    Ignition switch ACC

Text in Illustration 
*a
Front view of wire harness connector
(to Radio Receiver Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Radio Receiver Power Source Circuit (Jun 2011 – Oct 2011)Radio Receiver Power Source Circuit (Aug 2012 – Jul 2013) →