2014 Hilux · Service Manual BODY ELECTRICAL

Radio Receiver Power Source Circuit

Circuit diagnosis · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

DESCRIPTION

This circuit provides power to the radio and display receiver assembly.

WIRING DIAGRAM

E281749E02

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - BATTERY AND BODY GROUND)

  1. E281750E06
    Disconnect the radio and display receiver assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R23-7 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    R23-4 (B) - Body ground
    Always
    11 to 14 V
    R23-3 (ACC) - Body ground
    Ignition switch ACC
    R21-1 (IG) - Body ground
    Ignition switch ON

Text in Illustration 
*a
Front view of wire harness connector
(to Radio and Display Receiver Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Radio Receiver Power Source Circuit (Aug 2012 – Jul 2013)COMPONENTS (Jun 2011 – Jul 2013) →